The CNC machine is made of what was at hand, namely - a steel profile pipe of 40х20 mm, a piece of an old plate of a chipboard, threaded hairpins of M8, case bearings, furniture guides, a steel sheet 2 mm thick. Used a welding machine, an angle grinder (Bulgarian), a drilling machine (you can use an ordinary drill), a screwdriver.<br />The electronics of the project are as follows - control board ANNOY TOOLS GRBL1.1 Controller CNC3018 3AXIS Driver Board Support Offline XYZ Limit Switch for CNC Router CNC Engraving Machine,<br />drivers - A4988, stepper motors - Nema 17, laptop power supply. Also used a 220 volt engraver.<br />CNC milling machine, engraver, laser burner.<br /><br />Contact me: [email protected]<br />...<br /><a href="https://www.youtube.com/watch?v=4jZXx3ERlck" target="_blank" rel="nofollow">https://www.youtube.com/watch?v=4jZXx3ERlck</a>