This video outlines the general process of installing the Ultra HDMI kit into a Nintendo 64. Most notably, I thoroughly go over intermediate technique's for fine-pitch solder work that can be easily mastered by people with novice soldering experience. I use a generous amount of no-clean flux to demonstrate that it isn't something you should be afraid to use liberally. The no-clean flux that I use is neither corrosive or conductive, unspent. Consult the datasheet for your flux of choice, but STAY AWAY from water soluble (organic) fluxes, as the unspent deposits can be very caustic and WILL conduct. Once you improve your bodies, you'll be able to gauge the appropriate amount to dispense for good solder wetting. Even though I use a no-clean flux, I do clean the site thoroughly with an isopropyl/distilled water mix, even though I failed to include it here. There are no-flux chemistries that can't be properly cleaned with IPA. Again, consult your datasheet. You can see that in my SNESRGB SMD talks video.<br /><br />Make sure to Like, Favorite and Share this video and Subscribe!<br />...<br /><a href="https://www.youtube.com/watch?v=S5awMonAUa0" target="_blank" rel="nofollow">https://www.youtube.com/watch?v=S5awMonAUa0</a>